idrive door goes up 3/4 and stops

Add Comment | Related Links | TrackBack
Related Content

idrive door goes up 3/4 and stops

My wife went to open the garage door and it wouldn't work. I looked and the cables were wrapped all around the cable guides, but not in the grooves. I replaced one of the cables six months ago and replaced the other one last night. The garage door goes up smooth to the 3/4 point and then stops. It acts like there is no more travel from the cable guides/torque tube or something. The motor will pull the door to 3/4 and then stops, but I have to help the door down. After doing this I can't get enough slack on the emergency release to release the door. I have both dials set to 17 turns, because at 18 the door opens to 3/4 with the emergency release pulled down. Any ideas on what the issue may be. The door has been functioning properly for the last 4.5 years.

William Cockrell
Wed, 16 Sep 2009 01:58:36 +0000

I think the motor guide position is off after you reassembled it. See this tip: Wayne Dalton idrive Troubleshooting Tip #2 - Check the Motor Guide Position

Chieh Cheng
Mon, 19 Sep 2011 23:48:05 +0000

Add Comment | Related Links | TrackBack
Related Content

Did your message disappear? Read the Forums FAQ.

Add Comment

Spam Control | * indicates required field

TrackBack

TrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.

Send Ping | TrackBack URL | Spam Control

No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here.

Messages, files, and images copyright by respective owners.

Fun for Photographers

Get Our

Memecoins!

Fun for Photographers