Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jan 4, 2014 · My problem is when the weather gets below 40F the door stops intermittently while travelling up. This problem did not start until 4 or 5 ...

Dec 6, 2005 · During the install routine, the door moved up, but when it is ready to move down, it stalled again beeping three times. I did this several times ...

I tried to run the profile routine but it opens then tries to close then stops. I checked the wheels don't see anything that seems to be obstructing any of the ...

Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor ...

Then one day the door would not close with the drive, it locked up on something. So to close the door we have to use the safety release and lower the door ...

Jul 28, 2010 · the door does not appear to have a lower limit. it bangs into the floor too hard, and goes back up again before the arm can drop down. is ...

Nov 24, 2023 · Seeing the motion, I am guessing the idrive is either having a hard time starting the motion when the door is on top or it feels the obstruction ...

During programming the garage door may operate. Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure people ...