Wiki

Older Revision of Hyper Tough 20V MAX Power Tools Battery Interface

Revision: 20220410_191322 | All Revisions

Hyper Tough 20V MAX Power Tools Battery Interface

The Hyper Tough 20V MAX power tool uses 20-volt lithium ion (Li-Ion) battery packs. The battery packs probably contains five 3.6v lithium ion power cells that provides 18v and peaks at 20v when charged.

Comments & Discussion >>

Hyper Tough 20V MAX Battery Pin-Out

The photo below shows the pin-out on the battery.

• + is the battery positive terminal.
• The unmarked pin is the charging terminal. (See next section.)
• T is probably the NTC thermistor temperature sensor. NTC stands for Negative Temperature Coefficient.
• - is the battery negative terminal.

Comments & Discussion >>

Hyper Tough 20V MAX Slide-On Charger Pin-Out

The photo below shows the pin-out on the slide-on charger.

As you can see from the photo above, during charging, only the negative pin and the unmarked pin are connected.

Comments & Discussion >>

Copyright © 2004 - 2024. All Rights Reserved.