My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the detent pin all the ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jun 3, 2006 · The door should have a good balance where it doesn't raise or lower on its own. I would also recommend frequently lubing all rollers with a ...

9. Press the HomeLink™ button once more to operate the door. idrive™ garage door openers with YELLOW antenna wires are compatible with all HomeLink ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Aug 24, 2010 · Sounds like the motor in my iDrive just went. I will be calling the tech support tomorrow to see if there is a simpler solution but it worked ...

Dec 6, 2005 · Of course the idrive garage opener can't open an unbalanced door. Did idrive cause the spring to fail? No. So why did it come down? Read on.

Jan 4, 2014 · I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...

Jan 11, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

Feb 17, 2011 · I have a Wayne Dalton I drive that has failed twice in 5 years. The first was a board, the second a catastrophic spring or motor failure. Motor ...