Jun 3, 2006 · The door should run up - then down = then up and down again and that will set your open (bottom) and closed (top) stops. If your idrive won't ...

Apr 16, 2015 · With the door fully closed, if you hit the button to lift the door, the motor turns, the door does not move, and there is a mechanical grinding/ ...

The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor. I ran it ...

Dec 6, 2005 · It said that if the "door stops or reverses, and the opener beeps three or four times," then any of the following three is the problem:.

When you open a well-balanced garage door manually, all you do is use the torsion bar, springs, and cables to lift the door for you. That's what the iDrive does ...

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Jan 4, 2014 · The door works almost flawlessly, only a very rare stoppage part way up, rarely... Thanks to Ken for the idea to warm the drive. I had been ...

Jan 11, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

To clear the programming of all remote control devices, press and hold the DoorMaster™ light fixture program button, idrive™, Quan- tum™ or Classic drive™ ...

Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure people and objects are out of the way of the moving door ...