Jun 3, 2006 · Recently, my garage door became off-balance. Whether it's due to the earth shifting or the old cable drum about to fail is still being ...
The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor. I ran it ...
Mar 5, 2009 · Excerpt: I have a 12 year old I Drive Torquemaster that was working fine and just stopped opening and I get no beeps when i try to open, Ive ...
The HomeLink™ indicator light will be blinking during the training operation. When the HomeLink™ indicator light flashes rapidly or turns off (approx. 5 to.
Jan 4, 2014 · After heating up the iDrive, it did not hang up once going up or down. I am sure it will hang up in a few hours once the unit cools down again.
Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...
People also search for
Jan 2, 2019 · Hi,. I'm trying to find out what pins 1 and 3 on the iDrive terminal block do. They show a switch so wondering if that's for a hardwired wall ...
Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle ...
It seems it was MY fault because the torsion spring broke, the opener was not sensitive enough, or I did not set it right. Incidentallt Dalton's door panels are ...
Sep 19, 2011 · Once you've disconnect the idrive from the garage door, rotate the white plastic screw (with the idrive disengaged) until the black plastic ring ...