idrive does not close while profiling. idrive will not close. I tried to run the profile routine but it opens then tries to close then stops.

Apr 16, 2015 · With the door fully closed, if you hit the button to lift the door, the motor turns, the door does not move, and there is a mechanical grinding/ ...

Jun 3, 2006 · Recently, my garage door became off-balance. Whether it's due to the earth shifting or the old cable drum about to fail is still being ...

Aug 24, 2010 · Sounds like the motor in my iDrive just went. I will be calling the tech support tomorrow to see if there is a simpler solution but it worked ...

Jan 12, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

Jan 4, 2014 · I am sure it will hang up in a few hours once the unit cools down again. Does anyone have any ideas on how to fix this unit, short of replacing ...

The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor. I ran it ...

Mar 5, 2009 · No beeps when hitting the reset button. After checking the owner's manual I figured the fuse is blown. The circuit board has a rectangular ...

Use the programming instructions provided with your vehicle first. Follow these instructions if the HomeLink™ unit does not learn the transmitter, by using the ...

NOTE: idrive™ model only: The first transmitter command after programming will only open the door through a six inch up/down cycle. Normal door operation will ...