Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive independently from ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Jan 4, 2014 · I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

May 4, 2014 · Lately, the door opens fine but when it closes, it comes down to about 5' from the floor then it stops and reverse to full open. Follow the ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

LED will light or idrive ... Within 30 seconds, press and hold the desired transmitter button(s); LED will turn off or idrive™ powerhead will beep once.