NOTE: idrive™ model only: The first transmitter ... Keep remote controls away from children. Fatal ... Wayne-Dalton Corp. P.O. Box 67 Mt. Hope, OH 44660.

Wayne Dalton idrive - Remote Only Works a Few Inches Away From Opener. Mon ... idrive opens garage door 6 inches at a time. Tue, 27 Jan 2015 15:06:43 -0800.

Hold the end of the Wayne-Dalton hand-held transmitter approximately 1 to. 3 inches away from the HomeLink™ surface – keeping the HomeLink™ LED light in view. 5 ...

Jun 3, 2006 · This apparently is an issue as the wire was being pinched on the door open / close cycle.

1. Ensure the door is running smoothly before installation. 2. Throw away the plastic cable retainers as they can cause binding. 3. Leave 3/8" gap between drive ...

Pulling the release cable does not free the motor. I backed the detent pin all the out so I can move the motor, but it only moves with the shaft. I got into ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

May 8, 2011 · Wayne Dalton idrive Moves Only One Foot. My door will open about 1 foot then close. I replaced the board and it still does the same thing.

Jan 4, 2014 · I am sure it will hang up in a few hours once the unit cools down again. Does anyone have any ideas on how to fix this unit, short of replacing ...

Dec 6, 2005 · To run the install routine, press and hold the profile button (only on the Wall Station remote). The idrive opener will open the door fully and ...