Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive independently from ...

Nov 15, 2015 · I have a Genie garage door opener. It operates intermittently. At first, it just won't work once in a while. Now it only works once every few ...

Apr 16, 2015 · It does NOT seem to be a fuse, as the motor runs. It does NOT seem to be a door balance/resistance issue, as the door moves smoothly, evenly and ...

Nov 15, 2015 · Apparently, capacity wearing out and failing over time is a reoccurring problem for all Genie screw drive garage door openers. EPCOS Motor Start

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Sep 12, 2009 · With the motor in the up position and manual release cable pulled, the torque tube does not turn freely in the Idrive. It is hard to turn and ...

I have seen a few conditions were the door would stop or stop/reverse after about one year of operation. -Mine. The solution was to re-lub the motor shaft, ...

Sep 19, 2011 · Easiest way is to disconnect the geared drive wheels from the torsion bar. Once you've disconnect the idrive from the garage door, rotate the ...

The motor does not lift up far enough to allow the door to open. If you use the emergency handle to disengage the motor and move it to the "opening" position, ...