Feb 17, 2016 · Just thought I would throw this up here. For those who say you cannot put a Liftmaster 3800 on a Wayne Dalton Torquemaster, please see my video ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

To program the transmitter: 1. Place the emergency disconnect handle in the manual door operated position. This is for safety reasons. 2. Press program button ...

Press and hold the desired HomeLink™ channel/button – LED should flash slowly (indicating empty channel). Continue holding the HomeLink™ but- ton, and press and ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

May 4, 2014 · Lately, the door opens fine but when it closes, it comes down to about 5' from the floor then it stops and reverse to full open. Follow the ...

Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

Before your Wireless Keypad will be able to operate the opener, there are several programming steps that have to be completed. PLEASE READ ALL INSTRUCTIONS.

Mating the Liftmaster 3800 to Wayne Dalton TorqueMaster. Wed, 17 Feb 2016 16:30:11 -0800. iDrive versus Liftmaster 3800. Tue, 05 Jan 2016 12:07:03 -0800. Wayne ...

Dec 6, 2005 · During the install routine, the door moved up, but when it is ready to move down, it stalled again beeping three times. I did this several times ...