Jun 3, 2006 · I just changed the glass fuse, got it at radio shack(250v 4amp slow burn, smaller sized, and the motor started working. It did trip my GFI ...

It seems it was MY fault because the torsion spring broke, the opener was not sensitive enough, or I did not set it right. Incidentallt Dalton's door panels are ...

My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the detent pin all the ...

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...

Jan 4, 2014 · Today (1/4/2014) it is about 20F. I took a heat gun (on the low setting) to the unit to warm it up to about 80F. After heating up the iDrive, it ...

Jan 11, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Sep 12, 2009 · My Idrive model 3661-372 has been working ... With the motor in the up position and manual release cable pulled, the torque tube does not turn ...

Aug 24, 2010 · Sounds like the motor in my iDrive just went. I will be calling the tech support tomorrow to see if there is a simpler solution but it worked ...

Mar 5, 2009 · After the snow storm that recently hit our area one of our idrive doors became frozen stuck. When I tried to open it it hummed for a few seconds ...