Jun 3, 2006 · When I pushed the up/down button and the profile button, the garage door opener just chirped and beeped. Calling the customer service resolved ...

When you open a well-balanced garage door manually, all you do is use the torsion bar, springs, and cables to lift the door for you. That's what the iDrive does ...

Jan 4, 2014 · I am sure it will hang up in a few hours once the unit cools down again. Does anyone have any ideas on how to fix this unit, short of replacing ...

Continue holding the HomeLink™ but- ton, and press and hold the desired button on the Wayne-Dalton transmitter for approximately 3-5 seconds. The HomeLink™ LED ...

Jul 28, 2010 · You will have to profile the garage door opener. After you do so, the idrive will know the upper and lower limit. Chieh Cheng Wed, 28 Jul 2010 ...

Apr 16, 2015 · With the door fully closed, if you hit the button to lift the door, the motor turns, the door does not move, and there is a mechanical grinding/ ...

Dec 6, 2005 · To run the install routine, press and hold the profile button (only on the Wall Station remote). The idrive opener will open the door fully and ...

Aug 3, 2008 · No, there isn't a two second delay before pushing the button and the iDrive opener responds with chirp. The opener is set in motion immediately.

Jun 26, 2007 · It got stuck a few times in the past week. I pull the quick-release handle and played with the door a bit. It's obvious that it's bottom heavy.

Wayne Dalton Garage Door opens in two foot increments. Sun, 22 Feb 2015 13:59 ... idrive opens garage door 6 inches at a time. Tue, 27 Jan 2015 15:06:43 -0800.