It will open but will not close. The motor strains when trying to close as if there were an obstruction. When I release the door to close manually, if moves ...
idrive opens fine, but won't close. Got an I-drive unit that will open fine, then when you go to close it after pushing the wall mount switch, it goes down ...
Jun 3, 2006 · and closed (top) stops. If your idrive won't complete the install routine - you will need to isolate the problem to continue. I hope this helps.
idrive opens upon close. Have had this IDrive since the house ... Mine went up, then down, but would not go up again. ... If the door works fine, then I would try ...
Jan 11, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.
Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...
Apr 23, 2012 · Pulling the release cable does not free the motor. I backed the detent pin all the out so I can move the motor, but it only moves with the shaft ...
Dec 6, 2005 · Then it will close the door completely. Finally, it will perform the up and down cycle one more time. During the install routine, the door moved ...
Jan 4, 2014 · When I put the red handle in the manual position the door freely moves from full open to full close and from full close to full open. The ...
5. Press and hold the desired HomeLink™ channel/button – LED should flash slowly (indicating empty channel). Continue holding the HomeLink™ but-.