Jun 3, 2006 · Is there another forum for TorqueMaster idrive? ... Obstruction encountered. Infrared sensor ... I disengaged the I-drive and the door moves freely ...

Nov 24, 2023 · Based on the "Troubleshooting" section of the instruction manual, there are three possibilities: Obstruction encountered. Infrared sensor ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Apr 23, 2012 · My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the ...

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...

Dec 6, 2005 · There is no obstruction. And the infrared (Photoelectric Safety Sensors) sensors were lined up just fine before. But when I looked down at ...

Aug 3, 2008 · ... detects resistance before getting to the "close" position, it reverses itself. Technically, it detects an obstruction every time it closes.

Jan 11, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

Aug 24, 2010 · Sounds like the motor in my iDrive just went. I will be calling the tech support tomorrow to see if there is a simpler solution but it worked ...

Press same tranmitter button(s) again; door should operate. Transmitter is now programmed to operator. NOTE: idrive™ model only: The first transmitter command ...