Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the ...

Jan 29, 2006 · The swing arm is based on the physical torque of the motor in the idrive. It won't move until the door comes to a stop due to hitting the floor.

Jan 4, 2014 · After heating up the iDrive, it did not hang up once going up or down. I am sure it will hang up in a few hours once the unit cools down again.

Dec 6, 2005 · I press the remote and the door moved up smoothly. Push the button again, but the door wouldn't come down. The opener beeped three times ...

During programming the garage door may operate. Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure people ...

Sep 19, 2011 · Easiest way is to disconnect the geared drive wheels from the torsion bar. Once you've disconnect the idrive from the garage door, rotate the ...

1. Ensure the door is running smoothly before installation. 2. Throw away the plastic cable retainers as they can cause binding. 3. Leave 3/8" gap between drive ...

Jul 28, 2010 · the door does not appear to have a lower limit. it bangs into the floor too hard, and goes back up again before the arm can drop down. is ...