Jan 4, 2009 · Any suggestions on how to remove these springs from the tube (and install the new ones)?. Marco Tue, 24 Feb 2009 00:08:21 +0000. I can't ...

Wayne Dalton idrive for Torsion Springs - Solution #1: Install Custom Upper Limit to Successfully Profile. Fri, 24 Nov 2023 22:42:56 -0800. idrive motor won't ...

Jul 16, 2008 · install idrive® for torsion springs garage door opener. ... wayne-dalton ... NOTE: Before performing custom upper limit, first profile must be done.

Dec 6, 2005 · To run the install routine, press and hold the profile button (only on the Wall Station remote). The idrive opener will open the door fully and ...

Jun 26, 2007 · Based on this "Mounted Garage Door Opener features Force and Limit Profiling" article, the Wayne Dalton iDrive does remember the force and limit ...

When you open a well-balanced garage door manually, all you do is use the torsion bar, springs, and cables to lift the door for you. That's what the iDrive does ...

Continue holding the HomeLink™ but- ton, and press and hold the desired button on the Wayne-Dalton transmitter for approximately 3-5 seconds. The HomeLink™ LED ...

Jun 3, 2006 · When I pushed the up/down button and the profile button, the garage door opener just chirped and beeped. Calling the customer service resolved ...

The solution was to re-lub the motor shaft, There are two hex screws that hold the motor and found on top of the motor. Easy to get to with the motor pivoted ...

My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the detent pin all the ...