Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

Apr 23, 2012 · Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive ...

Jan 4, 2014 · Today (1/4/2014) it is about 20F. I took a heat gun (on the low setting) to the unit to warm it up to about 80F. After heating up the iDrive, it ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

Tue, 27 Jan 2015 15:06:43 -0800. Wayne Dalton idrive Torquemaster model 3661 Closes Half-Way ; Tue, 13 Jan 2015 10:42:24 -0800. no tension in the cables ; Tue, 30 ...

NOTICE: Programming HomeLink™ requires Wayne-Dalton transmitter that is programmed to the idrive™. See idrive™ manual. ATTENTION: Use the programming ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

© Copyright 2004 Wayne-Dalton Corp. Wayne-Dalton Corp. P.O. Box 67 Mt. Hope, OH 44660. (888) 827-3667 www.wayne-dalton.com. 3 - Button Transmitter. Model No.