Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor ...

Nov 24, 2023 · Wayne Dalton idrive for Torsion Springs - Solution #1: Install Custom Upper Limit to Successfully Profile · Obstruction encountered. · Infrared ...

When I stumbled into a review of the iDrive it seemed like the perfect solution to my problem. I got the iDrive for torsion springs. The installation took ...

Apr 16, 2015 · It gets slightly tighter up near the top of its range of motion, but not much. If you now release the emergency handle (with the door up) and ...

Jun 3, 2006 · But nevertheless, it had caused my Wayne Dalton idrive for Torsion Spring to fail. ... Ryan R. ... resistor location is a "fuse resistor". It's ...

Dec 6, 2005 · After losing one of the two torsion-springs. The door is no longer counter-balanced and is very heavy. Of course the idrive garage opener can't ...

Jun 26, 2007 · It got stuck a few times in the past week. I pull the quick-release handle and played with the door a bit. It's obvious that it's bottom heavy.

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Jan 4, 2014 · I am sure it will hang up in a few hours once the unit cools down again. Does anyone have any ideas on how to fix this unit, short of replacing ...