1 Measure your door for a backset (A) of 2-3/8" (60mm) or 2-3/4" (70mm). 2 This step is for adjustable latch only: If backset (A) of door measured 2-3/4". 1. (A) ...

A little while back, I was replacing the deadbolt and the door knob on my garage door. But the swinging door just won't hold still. It kept flopping around ...

Dispose of used batteries properly. To replace battery perform the following steps: A. Snap open case with a coin and remove old batteries. B ...

The following steps describe the process to activate a transmitter's security code. 1. Press and hold the large transmitter button.

Jul 16, 2008 · Installing Opener Place the opener over the torsion tube and between the two gear assemblies. Center the mounting bracket on the mounting ...

Jun 3, 2006 · I pulled the disconnect handle. raised the door by hand half way, set a garbage can under it to hold while I worked. When finished, for some ...

Nov 15, 2015 · It might open it once, but won't be able to close it. Instead, it just sits there and hums. After a while, maybe an hour, it would work again ...

Use the programming instructions provided with your vehicle first. Follow these instructions if the HomeLink™ unit does not learn the transmitter, by using the ...

I have seen some cheap doors in my days, but come on, why make a door you can stick a pencil through. The idrive motor is a good concept, that is all. Mike

The RM-VLZ620 provides centralized control of all of your. Audio Video devices, saving the trouble of operating other A/V devices with different remote controls ...