Jan 12, 2024 · I have a idrive for Torsion springs ( not the pro). The locking arm is getting stuck between door panels & wall before the door can fully close.

The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor. I ran it ...

Apr 16, 2015 · If you pull the emergency release, you can raise the door easily with one hand, and if you let go it does not fall. It gets slightly tighter up ...

Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The ...

1. Ensure the door is running smoothly before installation. 2. Throw away the plastic cable retainers as they can cause binding. 3. Leave 3/8" gap between drive ...

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Press same tranmitter button(s) again; door should operate. Transmitter is now programmed to operator. NOTE: idrive™ model only: The first transmitter command ...

Jan 4, 2014 · When I put the red handle in the manual position the door freely moves from full open to full close and from full close to full open. The door ...

May 4, 2014 · Lately, the door opens fine but when it closes, it comes down to about 5' from the floor then it stops and reverse to full open. Follow the ...

Dec 6, 2005 · After losing one of the two torsion-springs. The door is no longer counter-balanced and is very heavy. Of course the idrive garage opener can't ...