Apr 23, 2012 · Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive ...

The solution was to re-lub the motor shaft, There are two hex screws that hold the motor and found on top of the motor. Easy to get to with the motor ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Sep 12, 2009 · With the motor in the up position and manual release cable pulled, the torque tube does not turn freely in the Idrive. It is hard to turn and ...

Jun 3, 2006 · It would beep twice and either move an inch or do nothing at all. I was convinced the motor was not burned so I opened the covers and evaluated ...

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Feb 17, 2011 · I have a Wayne Dalton I drive that has failed twice in 5 years. The first was a board, the second a catastrophic spring or motor failure. Motor ...

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...

The idrive motor is a good concept, that is all. ... Leave 3/8" gap between drive wheel and housing as the jack shaft can shift sideways causing binding if gap is ...