|
I-drive motor not engagingI just recently had to replace the "internal disconnect cable" on my I-drive. After finally getting the new cable threaded and installed, I now have a new problem. When trying to open the door the motor does not engage into the drive ring ( this is like a square tooth gear) on the right side of the motor. After a lot of review I have determined that the internal release cable pulls this gear out at the end of the door closing cycle. The problem is I don't know how to re-establish the correct cable position or final motor position. It also seems that the internal cable does not completely release. Do I need a new spring on the cable guide? I am really stuck on this one. Any ideas are appreciated B. Buck
Did your message disappear? Read the Forums FAQ. Add Comment
TrackBackTrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.
No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here. Messages, files, and images copyright by respective owners. |
Articles
|
Wiki
259 Users Online
Get Our
|
|
Copyright © 2004 - 2025. All Rights Reserved. |
|
Related Links
|
TrackBack
