|
I-Drive for Torquemast - motor won't liftI see somebody asked this question a few years ago and didn't get a response. I'll try again, I did post this question in an existing string but now wish I hadn't done that. My I-Drive for Torquemaster (installed in 2004) recently began having an issue with the motor not lifting far enough during the opening sequence. The motor does not lift up far enough to allow the door to open. If you use the emergency handle to disengage the motor and move it to the "opening" position, the door will then open if you activate it from the wall station or the remote. Door will also close normally after it opens. When you attempt to open the door again, the motor again only lifts about half-way up then stops, and you have to repeat the manual disengagement. The manual only suggests the the counterbalance spring tension is too high, or the install routine needs to be run again. I've adjusted the spring tension and re-run the installation routine, but it does not fix the problem. I'm hoping somebody will read this and be able to provide some insight into getting this solved. Best, Outboardguy
Did your message disappear? Read the Forums FAQ. Add Comment
TrackBackTrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.
No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here. Messages, files, and images copyright by respective owners. |
Articles
|
Wiki
224 Users Online
Get Our
|
|
Copyright © 2004 - 2024. All Rights Reserved. |
|
Related Links
|
TrackBack
